Skip to main content
615 Chimney, chimney sweep and repair company in Nashville TN 615-431-3789

Masonry Repair & Rebuilding

Chimney crown repair and rebuilds that stop water at the top of the stack

We repair or rebuild cracked, crumbling and flat crowns with a proper slope and overhang, so rain runs clear of the brick.

Call or text today615-431-3789

Request a site visit

Tell us about your project. We will contact you to confirm the details and set up a time to visit.

Or call 615-431-3789

By sending this you agree that we may contact you about your project. See our Privacy Policy.

Prefer to type? Text your request to 615-431-3789

Chimney Crown Repair & Rebuilds

The crown is the roof of the chimney. When it cracks or crumbles, rain goes straight into the masonry below and the damage spreads down the stack. Many chimneys were built with a thin layer of mortar on top instead of a real crown, and those fail early.

We break out a failed crown, form and pour a new one with an overhang and a drip edge, reinforce it and seal the joint between the crown and the flue liner with flexible sealant. For smaller cracks, we can repair and coat the existing crown. Around Middle Tennessee, where freeze and thaw are hard on exposed masonry, a good crown is among the most useful repairs a chimney can have.

What you get

Done right, from the first walk-through

01

Poured and reinforced

A real crown, not a thin skim of mortar.

02

Sloped with an overhang

Water runs off and drips clear of the brick.

03

Sealed at the flue

Flexible sealant between the crown and the liner.

04

Repair or replace

We tell you which makes sense.

The process

How your service comes together

  1. 1

    Inspect the top

    We check the crown, the liner and the top courses of brick.

  2. 2

    Remove and form

    We remove the failed crown and form a new one with reinforcement.

  3. 3

    Pour and seal

    We pour the crown, finish it and seal the flue joint.

FAQ

Common questions about crown repair

Can a cracked crown be patched?

Small cracks can be sealed, but a badly cracked or flat crown should be rebuilt.

What is a crown for?

It sheds water off the top of the chimney so it does not enter the masonry.

How long does a crown rebuild take?

Usually a day or two, with time for the concrete to cure.

Let us help with your crown repair

Call, text or send the form. Tell us about the property, what you have and what you would like, and we will take it from there.

615-431-3789Text